![]() If you haven't already bought the 20P, make sure it's version 9.12 or higher or consider getting a VISTA-21iP () instead. I would suggest the iGSMV4G () as it's a dual path communicator that can do IP or dual path (IP backed up by cellular). Keep in mind, with a 20P, you'll need an alarm communicator connected to the system if you want Total Connect 2.0 service. Yes, if you enter installer mode and use the *56 section of programming, you should be able to view the current zone configuration. ![]() If I can't figure it out I can always reset to a template but I'd prefer not to do this. I suspect there is a simple mistake I'm making but I can't find an answer for this old model. I've tried everything but I cann't get a two digit number to take. I can get into programming fine but if I try to change slot *34 and press 60 it will always register as 06. They are super short (less that 10 seconds). However, I can't reset the entry/exit delays. I was able to reset everything by cutting power and setting new codes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |